Showing posts with label Upholstery. Show all posts
Showing posts with label Upholstery. Show all posts

Tuesday, May 6, 2014

Easy No-Sew Pillow Slipcovers

You know when you want to update the look of room, but don't have much money? (Yea, it happens to me all the time) Pillows are usually an easy way to update a room and give it some color that isn't too expensive, if you find them cheap. The problem is, I've been looking at the discount stores and haven't seen much that I like. I did, however, have extra fabric from curtains on hand, and pillow forms that were still plush enough to use. So I decided to DIY!!! I am pumped with the result.


All you need to make these no-sew pillow slipcovers is the pillow form, fabric, iron-on hem tape (like HeatnBond No-Sew Hem), scissors, and an iron.

Here's what you do:
1. Measure the pillow. (Mine was 17 inches.)













2. Cut out the fabric and extra inch on each side and 6 inches top and bottom. (My fabric was 19 inches wide by 46 long)













3. Fold over the end of the short edge by about 2 inches. Cut the hem tape to fit underneath, and iron backside of the fabric together.













4. Flip the fabric over. Use a guide if you want to fold the fabric so that the hemmed edge rests in the middle of the the cover. (Mine was a 8 1/2 inches) Iron around the form (without any hem tape) so that it is easier to handle the fabric. Take the guide out.


5. Cut hem tape to fit right inside each raw edge of fabric. Iron down the hem tape to create the side seams.














6. Let the fabric cool, then flip the cover inside out and stuff the pillow inside. Ta-da!! Your new pillow slipcover! It would be easy to add some embellishment too: buttons, ribbon, etc at this point.

































Tuesday, August 13, 2013

Fabric Paint Chair Revamp!

I snagged this chair at Valley Thrift store about a week ago for .69. That's right.... sixty-nine cents! Who priced this, I'm not sure, but it was destined to be mine. The only problem was that it was a little faded. I was sure I could find some fabric paint to spruce it up, and I did. Both Jo Ann's and Michael's carried Simply Spray fabric paint. After I cleared out Jo Ann's Blue Jay stock, I went to Michael's. (They actually had several other brands also, some that came in a pump bottle instead of a spray. I'm not sure how they would work but I just might try it sometime.)

On a technical note, I was super irritated because the spray kept jamming. I actually returned a bottle to the store because it sprayed for a whole two seconds and then didn't give me anything else!! Grrr! I ended up using about 6 bottles of the 2.5 oz size. With coupons and all, I think it cost me about $25 to change the color of the chair.

I think the key with this project was to stay in the same color family. For example, I wouldn't have tried to make the chair red- it might have ended up looking purple or something. So I really just brought the original color back to life. After taping off the wood framing that showed, I tried to saturate the chair as best I could, then let it dry. Once it dried I could see if I was uneven in any areas and spray again to cover better. The nice thing about this type of paint was that it doesn't need to heat set or be washed, so I works for a chair that can't go through the laundry!

You can see the before and after pictures below, and also a picture with the cushion turned over to see the difference.